Flex TL 4000 18.0/230 Instrucciones De Funcionamiento página 19

TL 4000 18.0/230
The light has a three-stage brightness
adjustment, providing different light
intensities for your operation.
■ Press the On/Off switch to turn on the light
in the maximum brightness stage.
■ Press the On/Off switch again to change to
the medium brightness stage.
■ Press the On/Off switch the third time to
change to the minimum brightness stage.
■ Press the fourth time to turn the light off.
Maintenance and care
WARNING!
Remove the battery before carrying out any
work on the power tool.
If the external flexible cable or cord of this
luminaire is damaged, it shall be replaced by
a special cord or cord exclusively available
from the manufacturer or his service agent.
Cleaning
■ Clean the power tool and grille in front
of the vent slots regularly. Frequency of
cleaning is dependent on the material and
duration of use.
Spare parts and accessories
For other accessories, in particular tools
and polishing aids, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
Disposal information
WARNING!
Render redundant power tools unusable:
mains operated power tool by removing
the power cord,
battery operated power tool by removing
the battery.
EU countries only
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled.
NOTE
Please ask your dealer about disposal options!
-Declaration of conformity
We declare on our sole responsibility
that the product described in "Technical
specifications"conforms to the following
standards or normative documents:
EN 60598 in accordance with the
regulations of the directives 2014/30/EU,
2006/42/EC, 2011/65/EU.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Peter Lameli
Technical Head
01.10 .2022;FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Exemption from liability
The manufacturer and his representative are
not liable for any damage and lost profit due to
interruption in business caused by the product
or by an unusable product.
The manufacturer and his representative are
not liable for any damage which was caused by
improper use of the product or by use of the
product with products from other manufacturers.
Klaus Peter Weinper
Head of Quality
Department (QD)
19