Reese Towpower 21141 Guía De Instrucciones página 2

INSTALLATION INSTRUCTIONS
6.25-in
Highest rise position
1. HITCH BALL SELECTION - Ball diameter must match trailer
coupler size. The three most common sizes are
1- 7/8", 2", and 2-5/16". Select ball with 1" threaded shank
that is V-5 rated equal to or greater than trailer
gross vehicle weight rating (GVWR).
WARNING: Raised balls usually have reduced load ratings.
Ball rating must equal or exceed trailer GVWR.
2. ATTACH BALL TO MOUNT - REESE standard height hitch
balls with 1" shank are supplied with lockwashers and nuts.
Always use a lockwasher and place washer next to nut.
Ne PAS utiliser le montant à
rotule dans cette position pour
le remorquage. Cette position
Peut être utilisée pour
Le remisage seulement.
PAGE 2
7.50-in
Lowest drop position
Unless otherwise specified by ball manufacturer torque
ball nut to 250 ft/lbs. for 1" nut after mount is attached to
hitch.
3. ADJUST BALL HEIGHT - Insert hitch bar into hitch box and
install pull pin. Place mount onto hitch bar; move up or
down for proper height. The holes are 1.50" apart. Hitch bar
may be used either up or down.
4. Always offset ball mount towards tongue of trailer. Never
towards tow vehicle.
21141IN Rev B • Questions? (800) 234-6992 • ReeseBrands.com
DO NOT use ball
mount In this
position