Wesco WS2932 Manual De Instrucciones página 17

OPERATION
INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Intended Use
The power tool is intended for sawing and separating
wooden materials, plastic, plaster, non-ferrous metals and
fasteners (e.g. nails and clamps) as well as for working
on soft wall tiles and for dry grinding of small surfaces. It
is especially suitable for working close to edges and for
flush cutting.
1. INSTALLING AND REMOVING THE
BATTERY PACK
A) TO REMOVE THE BATTERY PACK (See
Fig. A1)
Depress the Battery Pack Release Button (2) firmly first
and then slide the Battery Pack out from your tool.
B) TO INSTALL THE BATTERY PACK (See
Fig. A2)
Slide the fully charged Battery Pack onto the tool with
sufficient force until it clicks into position.
2. CHARGING THE BATTERY PACK(WS9890)
(SEE FIG. B1)
NOTE:
a) Do not use any charger other than that
specifically provided for use with the
equipment.
b) If the battery pack is very hot you must
remove your battery pack from the
charger and allow time for the battery to
cool down before recharging.
c) The battery in your new tool is not
charged when it leaves the plant.
Therefore it must be full charged before
using the first time
d) Please charge the battery to reach full or
no less than half charge before storage. If
the tool will not be used for long periods
of time, charge the battery every 3-6
months
1). Plug the charger into an appropriate outlet. The light
will be green.
2). Place the battery pack into the charger, the light will
turn to red to indicate the charging process has started.
3). When charging is completed, the light will turn to green.
The pack is now fully charged, unplug the charger and
remove the battery pack.
Note: If the battery pack is locked in the
EN
charger, press the battery pack release
button and remove it.
Warning: When battery charge runs out
after continuous use or exposure to
direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
Light ON/OFF
Red on
Green on
CHARGING YOUR BATTERY PACK (WS9897)
(SEE FIG. B2, B3, B4)
Do not use any charger other than that
specifically provided for use with the
equipment.
If the battery pack is very hot you must
remove your battery pack from the charger
and allow time for the battery to cool down
before recharging.
Please charge the battery to reach full
before storage. If the tool will not be used
for long periods of time, charge the battery
every 3 months.
Charging procedure
1) Plug the charger into an appropriate
outlet. The light will be green.
2) Slide the battery pack into the charger,
make sure the battery is in the
Correct charge position firmly. The light
will turn to red to indicate the charging
Process has started.
3) When charging is completed, the light will
turn to green.
4) After fully charged, unplug the charger
and remove the battery pack.
Note:
If the battery pack is locked in the charger,
press the battery pack release button and
remove it.
Warning: when battery charge runs out
after continuously use or exposure to
direct sunlight or heat, allow time for the
tool to cool
Down before re-charging to achieve the full
Status
Charging
Fully Charged
17