Publicidad
Idiomas disponibles
Idiomas disponibles
J3 inserted: timer controlled activation - J3 disinserted: ON/OFF activation
J4 inserted: binding posts 10 and 12 are bridged - J4 disinserted: the function is enabled by an exter-
nal potential free contact (twilight switch).
Procedura di programmazione del temporizzatore:
- press and hold down "P2" for about 3 seconds, until the "Pr" symbol appears flashing on the
display D1.
- press "P2", "Hr" will flash for a couple of seconds; set the hours (from 0 to 23 hrs) by pressing "P1".
- press "P2", "Mn" will flash for a couple of seconds; set the hours (from 1 to 59) by pressing "P1".
- to confirm press and hold down the button"P2" until the display switches off.
FUNCTION MODE
Timer mode (jumper "J2" inserted)
If a command is received (via radio or TD) when the radio programmer is enabled the output will be
activated for the set time ( "tr" will appear on the display). Each command received when the output
is enabled will a reactivate the timer. If the contact "EN" is opened (radio programmer disabled) the
output will be disactivated (symbol "--" on the display). To reactivate the output send a command with
the radio programmer enabled.
ON/OFF (jumper "J3" disinserted)
If a command is received (via radio or TD) when the radio programmer is enabled and the output at
rest, the output will be activated ( "On" will appear on the display). If a command is received when the
output is already activated the output will return to the "at rest" position (the display will switch off).
If the contact "EN" is opened (radio programmer disabled) the output will be disactivated (symbol "--"
on the display).
To reactivate the output send a command with the radio programmer enabled.
Note: Commands sent while the radio programmer is dasabled will have no effect .
16
Publicidad
