Publicidad
Idiomas disponibles
Idiomas disponibles
• Rapid memorising procedure
This procedure allows you to enable a new transmitter (from a remote position) with the help of a
transmitter that has already been memorised in the system. As the presence of the receiver is not
required this procedure can be carried out in any remote location (for example in your chosen sales
outlet).
Access to the "rapid memorising" procedure can be enabled or disabled on the receiver by
inserting (or removing) the jumper "J2" R.MEMO:
• Jumper "J2" R.MEMO inserted: the rapid memorization procedure is enabled.
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
• Jumper "J2" R.MEMO not inserted: the rapid memorization procedure is disabled.
- Remove the upper cover from the transmitter to be memorised and from the transmitter that has
already been memorised as shown in the drawing below (det. a).
- Place the transmitter A, that has already been memorised in the receiver, beside the new transmit-
ter B (det. b).
- Using a pointed object press and release the MR button on both transmitter (in sequence or simul-
taneously).
- The orange LEDS on the transmitters will flash slowly.
- Press and release a channel button on transmitter A that is already present in the receiver (det. c).
- The led of the new unit B will remain lit for 3 seconds to confirm memorization (det. d).
Transmitter B will now command the receiver exactly like transmitter A.
1
3
2
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
MR
MR
A
B
A
18
All rights reserved. Unauthorised copying or use of the information contained in this d
B
Publicidad
