emergency battery backup
Two (2) 9 Volt batteries are required to operate the power down feature and are NOT included.
STEP 1
Disconnect the Power Supply from the input power cord.
Power Supply
STEP 2
Connect the Battery Backup Strap to
the (2) Alkaline 9 Volt batteries. Do not
mix brand name Batteries.
Control Box
Input Cable
STEP 3
Connect the end of the Battery Backup Strap to the input cable
that is attached to the control box.
Battery Backup Strap
Input Cable
Note: Detach the Battery Backup Strap after the emergency is
over, as the system will continue to draw power from the batteries
even if not in use.
STEP 4
Use the remote control to lower the base. If the base and
motors are fully or mostly raised, it is recommended to lower
the head, foot and lumbar sections separately rather than use
the flat button
Control Box
15