TEMPUR-PEDIC TEMPUR ERGO Manual Del Propietário página 6

safety precautions and usage statements
a temporary power source to get the base to a desired position.
Instructions on how to operate the Battery Backup Strap are on the
Emergency Battery Backup page(s).
Power Ratings:
INPUT: AC 100–240V 50/60 HZ 1.5A
OUTPUT: DC 29V 1.8A
WATTS: 52.2W
Product Ratings:
The lift motors are not designed to operate continuously for more
than two [2] minutes in an eighteen [18] minute time period or
approximately 10% duty cycle. Attempting to circumvent or exceed this
rating will shorten the life expectancy of the product and may void the
warranty.
Weight Limits:
The recommended weight limits on the
/ Full / Queen / King / Cal King / Cal King Split : 700 pounds
Maximum weight the bed can support per person is 250 pounds with
the weight evenly distributed across the head and foot sections. This
product is not designed to support or lift this amount of weight in
the head or foot sections alone. NOTE: Exceeding the recommended
weight restrictions could damage your
warranty. For best performance, you should enter and exit the
ERGO while it is in the flat or fully lowered position.
TM
TEMPUR ERGO fits easily inside bed frames, furniture beds and
TM
platform beds that are certified to hold a minimum of 950 pounds. If
using this adjustable base without the legs and placing directly on a
bed frame or platform bed, cross-bed supports (slats) are strongly
recommended to ensure TEMPUR ERGO
operation.
Exceeding this weight restriction could damage the bed
and/or cause injury and will void the warranty.
Acoustics:
In normal base operation the wheels, which allow the bed to maintain
its distance from the wall, will make contact with the steel platform
supports of the base creating a contact noise. When entering, exiting
or shifting weight on the base, this contact noise may be audible as the
wheels make contact. This is normal.
2
TEMPUR ERGO are: Twin Long
TM
TEMPUR ERGO and void your
TM
TEMPUR
maintains stability during
TM
Fabric Care:
To prolong the life of your fabric, protect from direct sunlight whenever
possible. For spot cleaning, wipe area with a light damp sponge or
vacuum with a soft brush attachment to remove particles. Keep at a
minimum of 30cm (12 inches) away from direct heat sources.
For deeper cleaning, blot liquid spills with a clean dry cloth. Wipe with
a clean cloth dampened with warm water. Do not wet excessively.
A soft bristle brush may be used to remove ingrained soil. Avoid
scratching by gentle brushing. Wipe with a clean cloth dampened with
warm water to remove residues after brushing. Dry in shade away from
direct heat.
If persistent marks remain visible after cleaning, seek professional
advice.
SAVE THESE INSTRUCTIONS.
FCC Compliance:
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
CAN ICES-3 (B)/NMB-3(B)