Publicidad
Idiomas disponibles
Idiomas disponibles
Branches that are high up or under tension can wedge the saw chain in the wood!
– Remove coarse dirt.
– Wipe down the device with a slightly damp cloth.
Cleaning the oil guide groove of the saw rail
NOTICE!
Device damage!
To clean the saw rail, use only a plas- tic spatula, never a steel tool.
– Remove the saw rail.
– Clean dirt from the oil guide groove of the saw rail with a suitable tool.
– Replace saw bar (Assembling the saw bar and saw chain ).
Re-tensioning the saw chain
item 6
– Loosen the fastening bolt (5) by approxi- mately one turn.
– Lift the tip of the saw bar slightly.
– Tighten the Chain Adjustment Ring for chain tension (4) until the chain lies on the underside of the
saw rail.
Lubricating chain wheel
item 9
The bearing of the chain wheel should be regularly lubricated at the front-end of the rail. About 1× in
a week in case of intensive use.
– Clean the lubrication hole.
– Apply little multi-purpose grease in the lubrication hole, while moving the chain with hand.
Sharpening the saw chain
DANGER!
Danger of death!
A worn or improperly sharpened chain can cause rebounds. Severe or even fatal injuries can be the
result!
18
Publicidad
