Steinberg Systems SBS-DK-1000 Manual De Instrucciones página 36

2. Screw in the stand [10] in the corner of the housing of the jacket base [1].
3. Apply the cross connector [7] on the stand [10] and screw on the clamping knob.
4. Place the plug [3] into one of the flask necks [2] and secure it with a clip.
5. Insert vacuum port [4] to one of the smaller flask necks [2].
6. Insert the external thermocouple rod [6] into the vacuum port opening [4], so that
the tip of the rod is located several centimetres above the flask bottom [2] (but it
does not touch the bottom).
7. Insert the boom with handle [5] into the cross connector [7] and grasp the external
thermocouple rod [6]. Secure parts in this position by turning the cross connector
and boom with handle knobs.
Cross connector
Vacuum port