Grill Chef 12120 Instrucciones De Montaje página 9

Timer Instructions
MAIN FEATURE
1. LCD count-down timer.
2. 4 digits display showing minute ( "M" mark ) and
second ( "s" mark ).
3. Timing range:1~99´59"
4. Buzzing output when timer counts down at last second.
5. Timer memory recall function.
6. [MIN], [SEC] individual buttons for minute and second
setting.
7. Clockwise function.
TIMING SETTING
1. Press MIN button to advance minute digits (deep sound
can be heard).
Press and hold MIN button for speed setting.
2. Press SEC button to advance second digits (deep sound
can be heard).
Press and hold SEC button for speed setting.
3. Press MIN and SEC button at the same time to reset
timer to zero.
TIMER START/STOP
1. After time setting is ready, press Start/Stop button once
and timer will start to count down. "M" and "S" marks
will flash when timer is counting.
2. Press Start/Stop button once and timer will stop. "M"
and "S" marks will stop flashing.
3. Press Start/Stop button once and timer will resume
counting again.
4. After buzzing stop, press Start/Stop button to return to
last setting time.
TIMER BUZZER ALARM
1. When timer counts down to 00 M 00 S , timer buzzing will
sound for 30 seconds.
2. Buzzing can be stopped by pressing any button.
TIMER MEMORY RECALL
1. After buzzing stops, press Start/Stop button once to
recall pre-set time and timer will count down for another
lap.
2. Press Start/Stop button once, timer will count down for
another lap.
PRODUCT SHOWS
CLOCKWISE FUNCTION
Press [MIN] and [SEC] button at the same time, when
display shows 00 M 00 S
Press [START/STOP] button once, going to clockwise.
BATTTERY REPLACEMENT
Follow the arrow direction to open the battery cover at
back side of timer.
Remove old battery, insert a new "AAA" battery as
indicated by the polarity symbols (+ & -) marked and
closed battery cover.
CLIP ATTACHMENT
The timer can clip on thin board or shirt pocket, using the
plastic clip at rear of timer. The timer can attach to iron or
a steel surface, using the magnet at the rear of timer. The
timer can stand on table surface, by flipping out the metal
stand bar at the rear of timer.
Environment friendly disposal
You can help protect the environment!
Please remember to respect the local
regulations: hand in the non-working
electrical equipment to an appropriate
waste disposal centre.
The packaging material is recyclable.
Dispose of
environmentally
friendly manner and make
it available for the recyclable material
collection-service.
the packaging in an
9