BFT RTD Manual De Instalación página 23

4) If s ome o f t he l ocations a re t aken u p a nd t he fi rst t ransmitter h as a n umber
other than 01 (ex. 35), it is entered in the first "N35" (135-235-335 etc.)
location available, which is followed by a sufficient number of free entry
locations:
RTD
-- 35 36 37 38 39 -- 135 136 137 --
5) In the case where more than 100 transmitters need to be stored in the
memory, each individual sales pack has to be entered by means of the
group menu. Each pack is identified by a specific serial number (S/N):
RTD
01 -- -- 100 101 --
01 -- -- 00 01 --
S/N 123.4 S/N 123.4
IMPORTANT NOTES:
• The sales pack can be divided into several groups (for ex. transmitters
from 01 to 50 in one system, from 51 to 65 in another, etc.) In any case,
any of the remaining transmitters can be used:
- on the same RTD receiver at a later time, in other groups or with manual/
automatic mode,
- in other RTD systems, other groups or with manual/automatic mode,
- in other transmitters with standard mode.
• Each transmitter contained in the pack is individually labelled according
to the following sequence: 123.4.01.
The first four figures (123.4) identify the pack serial number which is
identical for all the transmitters belonging to the same pack.
The last two figures (01 - 02 --> 00) are used to number the transmitters
in the pack in progressive order.
Each pack includes a printed form where to record the destination of
each transmitter, you are recommended to fill it in to facilitate future
maintenance, updating, replacement etc.
• In the case where no transmitters have been previously entered in the
RTD receiver, the first transmitter in the first group stored takes on the
master transmitter function. Mark it with the appropriate adhesive " key"
label.
Error messages
If any errors occur when entering groups, check that:
- the transmitters belong to one group pack (ERR1);
- the entry order is not reversed, the first transmitter must have an iden-
tification number lower than that of the last one. Also check that the
first and last transmitters belong to the same group (ERR2);
- the receiver has a sufficient number of consecutive free locations for
entering the transmitter group (ERR3);
- the key assigned to the channel (T1, T2, T3 or T4) is the same for the first
and the last transmitter entered.
5) RADIO-TRANSMITTER CLONING
INSTALLATION MANUAL
-- 200
35 36 37 -- -- 00
-- 200 201 -- -- 300 --
-- 00 01 -- -- 00 --
S/N 123.4
Rolling-code cloning / Fixed-code cloning
Refer to the instructions of the UNIVERSAL PALMTOP PROgRAMMER.
6) ADVANCED PROGRAMMING: COLLECTIVE RECEIVERS
Refer to the instructions of the UNIVERSAL PALMTOP PROgRAMMER.
7) MAINTENANCE
The maintenance of the system should only be carried out by qualified
personnel regularly.
8) DISPOSAL
ATTENTION: disposal should only be carried out by qualified personnel.
Materials must be disposed of in conformity with the current regulations.
In case of disposal, the system components do not entail any particular risks
or danger. In case of recovered materials, these should be sorted out by type
(electrical components, copper, aluminium, plastic etc.).
For battery disposal, refer to the current regulations.
The descriptions and illustrations contained in the present manual are not
binding. The Company reserves the right to make any alterations deemed
appropriate for the technical, manufacturing and commercial improve-
ment of the product, while leaving its essential features unchanged, at
any time and without undertaking to update the present publication.
ENGLISH
RTD - 23