Publicidad
Idiomas disponibles
Idiomas disponibles
IT
ES
To use the air intake in this type of outlet
you must perform the following operations
(fig. 9):
PT
– Remove the base of the air intake, using
GB
a tool to cut it off (a);
– Overturn the air intake (b) and replace
the seal (5) with the seal supplied in the
kit code 8089904;
– Insert the intake diaphragm supplied in
the kit code 8089904, pushing it in until
it is in contact with the beat.
You can now insert the extension or curve
in its housing to complete the intake (you
need not use any seal or sealant).
2.7.2
Outlet systems
The diagrams in fig. 9/a illustrate a num-
ber of examples of different types of sepa-
rate outlets.
KEY
1 Separate flue kit code 8089904
2a 90° elbow MF (n° 6) code 8077410
2b Isolated 90° elbows MF code 8077309
3a Extension L. 1000 (n° 6) code 8096003
3b Insulated extension L. 1000 code 8077306
3c Extension L. 500 (n° 6) code 8077308
4 Intake terminal code 8089501
5 Int.-est. ring kit code 8091500
6 Intake terminal code 8089500
7 45° elbow MF (n° 6) code 8077411
8 Condensation outlet L. 135 code 8092800
9 Doubler fitting code 8091400
10 Tile with articulated joint code 8091300
11 Roof outlet terminal L. 1390 code 8091201
12 Tee condensation outlet code 8093300
IMPORTANT: In type C52 the outlet and inlet flues must not come out on opposite walls.
74
(b)
5
3
2
1
C42
(a)
11
10
9
3
7
3
8
2
1
3
1
C32
C52
3
2
3
8
3
1
2
3
C82
1
C12
IMPORTANT: The three housings
on the diaphragm permit assem-
bly of the air intake in one posi-
tion only.
11
10
3
3
12
6
6
4
3
5
max 0,5 m
6
Fig. 9
Fig. 9/a
Publicidad
