Publicidad
Idiomas disponibles
Idiomas disponibles
IT
ES
Placing the boiler selector in position "OFF"
does not disconnect the electric board
from the power supply.
PT
Remove the three screws (9) locking the con-
trol panel in place and pull the panel forward
GB
until it can be tilted downward.
To access the components of the electrical
Before performing any kind of operation, disconnect the unit from the power supply using the bipolar switch of the
plant. Placing the boiler selector in position "OFF" does not disconnect the electric board from the power supply.
ATTENTION: After having removed the three screws, take out
the panel to tilt it downward.
KEY
1
Thermohydrometer
2
Time programmer seat optional cod. 8092214
4
Main PCB
5
Earth faston
6
Control panel protection
7
Cover (TA)
8
Connector (TA)
9
Fixing screw
76
panel, unscrew the four screws holding the
protective guard in place (6).
2. 1 1.2 Room stat connection (fig. 12)
To gain access to connector "TA", remove
IMPORTANT
9
6
7
1
2 5
8
the control panel cover (7) and connect the
room stat to the terminals 15-16 after
having removed the jumper.
The thermostat or timer-thermostat,
recommended for better room tempera-
ture control, must be class II as specified
by standard EN 60730. 1 (clean contact).
4
Fig. 12
Publicidad
