PNI Hunting 400C PRO Manual De Usuario página 6

Idiomas disponibles

MMS function brings additional costs. Check the costs for the MMS service and ask for

activation and settings to be made by your mobile operator if you want to use this feature.

VERY IMPORTANT WARNINGS

•

If you want to receive photo only by e-mail, disable MMS and FTP, and do not

enter phone numbers in the "Send To" menu.

•

If you want to use the MMS function, make sure that you have the active MMS

function on the SIM card and that you have previously tested the function in a

phone (meaning, you can send and receive an MMS with this card).

•

Test your SIM card in a phone and make sure you have Internet (mobile data),

SMS (for communicating with the Trail Camera smartphone application), credit

and MMS enabled.

•

The camera will automatically enter the 4G and MMS settings (only if you use

the function) when the SIM card is inserted. If the message "SIM Automatch

failed" appears on the screen, enter the settings manually, switch the "SIM Auto

Match" mode to "Manual", then enter the 4G and/or MMS settings (if you use

the function);

•

For emails, enter your email address in "Send to" - "Email" (up to 4 email

addresses can be set).

•

For MMS, enter your mobile phone numbers in "Send to" - "Phone" (up to 4

phone numbers can be set) (only if you use the function)

Note: For detailed menu settings, refer to the instructions in the menu options chapter

•

After you have finished all the settings, press the "Menu" button to return to the

home screen, then move the ON/SETUP/OFF switch to the ON position; the

LED will turn off and the camera enters the motion detection mode.

* In motion detection mode, the camera will automatically take photos and videos

and send photos to your mobile phone or email every time it detecs motion.

TESTING - EMAIL SENDING

After you have passed the previous steps (SIM card verification, signal, 4G settings

auto-configuration) just do the following:

1. Disable MMS and FTP from the camera menu; The SMTP function must be set to

Default (the default e-mail server of the camera).

2. Enter your email address that you want to receive the picture on in the "Send To"

3. Do not make other settings changes in the camera.

4. Press the Menu button until you exit the menu, and you will have the image taken

User manual