Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE BATTERIES IN THE REMOTE CONTROL
• Place the remote face down on a flat surface.
• Push the compartment cover into the direction of the arrow.
• Slide the battery compartment open.
• Remove the old battery and install the new one (CR2025) with the plus (+) sym-
bol facing up.
• Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in accordance with
your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING :Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.
REMOTE CONTROL
NOTE: PLEASE SET THE UNIT TO MODE -> ADDR, OTHERWISE
THE REMOTE CONTROL WILL NOT WORK
1. BRIGHTNESS & SPEED adjustment: Press
brightness and speed in programme mode
2. ON/OFF of the LEDs.
3. SELECT BASIC COLOR:
R: Warm white
G: cool white
B: warm white + cool white
W: warm white + cool white
4. COLOUR BUTTONS: Press one of the 12 colour buttons to select a
built-in programme.
CLEANING AND USING FREQUENCY OF PRODUCT
Please make sure that the light is power off before dismantling or maintaining, it's very important
to keep the light clean. Frequent cleaning will ensure maximum brightness output, but also prolong
the life time. It's suggested to use the high quality, professional glass detergent and soft cloth to
clean the light. It's not allowed to use alcohol or chemical solvent.
When the light doesn't work, please check if the fuse is burnt out or not. If it is, the same fuse
should be replaced, find out the faulty and restart the light. But please note the repair must be
handled by professional.
TECHNICAL SPECIFICATIONS
Power Supply .......................................................................................................................90-240V~50/60Hz
Consumption ............................................................................................................................................. 205W
Light source ............................................................................................................4 x 50W CW/WW COB LED
Dimensions .........................................................................................................................265 x 118x 200mm
Weight ....................................................................................................................................................... 2.46kg
IMPORTANT NOTE: Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
or
to set the
www.afx-light.com
7
EN
Publicidad
