Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
IMPORTANT!
To ensure safe operation of your product, please follow
these instructions carefully. Please keep these instructions for future reference.
IMPORTANT!
Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp edges. NEVER
use if any parts are missing or broken.
IMPORTANT!
Adult assembly is required.
IMPORTANT!
Always check that the high chair is locked in the open
position before using.
ATTENTION:
Carefully remove parts from box. Check that you have all the parts for this model
before assembling the high chair.
TO ASSEMBLE FRAME
WARNING:
on the frame when the seat is
not attached. Do not use frame
as a foot stool.
1)
• Take the left and right Upper Frame
Assemblies, push the legs apart until
fully open and locked. Push downward
on fold levers (left and right) to ensure
frame is locked open (Fig. 1a).
• Insert the front tube of the right and left
side Upper Frame Assemblies into the
Height Adjuster (Fig. 1b). The front tube
is easily distinguished from the rear
tube by the array of holes located on the
backside of the front tube.
5
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Push down
Do not sit
to lock open
Push
Fig. 1a
Fig. 1b
2)
• Squeeze the Release Handles on both
sides simultaneously and push the tube
through the Height Adjusters until it locks
in the highest position (Fig. 2).
3)
• Insert the legs into the ends of the Front
tube of both the right and left Upper
Frame Assemblies (Fig. 3a).
NOTE: Legs are properly connected
when the locking pins are lined up with
the holes on the ends of the Upper
Frame Assemblies. Make sure the
locking pins are engaged before use.
• Insert the other Legs into the ends of
the Rear tube of both the right and left
Upper Frame Assemblies (Fig. 3b).
NOTE: Legs are properly connected
when the locking pins are lined up with
the holes on the ends of the Upper
Frame Assemblies. Make sure the
locking pins are engaged before use.
4)
• Attach each of the Casters to the high
chair leg (Fig. 4). Snap casters into
bottom of the leg. Check that all four
Casters are securely fastened to the
high chair.
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Release Handle
Fig. 2
Fig. 3a
Fig. 3b
Fig. 4
6
Publicidad
