Publicidad
Idiomas disponibles
Idiomas disponibles
10-589
4. PROGRAMMING
Activating standard functions
The following standard functions have been programmed on the function key buttons:
Open the door.
Deactivate the ring tone.
Switch the light relay on the power supply.
Call up the camera image from one or more cameras.
Make a call:
• briefly press the button once for 2-way communication.
• press and hold down the button for 1-way communication (walkie-talkie principle).
Transmit a control function to operate a relay.
To activate these functions, you only need to connect the video internal unit to the external unit(s).
Programming alternative functions
Some of the function key buttons can also be assigned the following alternative functions:
If no call is in progress: switch on the light.
If a call is in progress, this button retains its standard function, i.e. opening the door.
Opening floor door. See chapter 'Activating floor bell push button'
If a call is in progress: end the call.
If no call is in progress, this button retains its standard function, i.e. deactivating the ring tone.
Making a second internal call
One of the following functions:
• Making a first internal call.
• Activating the 'ring-and-come-in' function.
• Activating call diversion.
For more information about programming via the power supply, see the power supply manual.
For more information about programming via the service unit, see the service unit (10-870) manual.
Activating floor bell push button
Function key button
can also be programmed to perform the 'open floor door' function:
1
➥
Press
for 8s until you hear a beep and both LEDs light up.
2
➥
Press
for 8s until you hear a beep and both LEDs go out.
3
➥
Wait 8s until you hear a beep and the LEDs go out.
The 'open floor door' function is now programmed on button
Up to 30s after a floor call, you can use button
mable relay (10-830, 10-836 or 10-837).
Setting the ring tone
You can set a different ring tone for each type of call via the function key buttons. You can choose from 13 ring tones.
1
➥
for 8s until you hear a beep and both LEDs light up.
Press
2
➥
Repeatedly press one of the following function key buttons to go through the different ring tones.
• Press
to select the ring tone for the external unit with an address equal to 0.
to select the ring tone for the external unit with an address different from 0.
• Press
to select the ring tone for the floor bell push button.
• Press
• Press
to select the ring tone for an internal call.
3
➥
Wait 8s until you hear a beep and the LEDs go out.
The last selected ring tones are stored in memory.
EN
.
to transmit control function 11 to open the floor door. Control function 11 can be learned by a program-
via the power supply or the service unit
via the service unit
via the service unit
via the service unit
15
Publicidad
