Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENT LIST
OPERATING INSTRUCTIONS
Intended use
This orbital sander is intended for dry sanding of Wood,
plastic, metal and filler material as well as painted surfaces.
The tool must not be modified or used for any other purposes
than the ones described in these instructions.
Power switch
• On: Shift the ON/OFF switch slider to "I" position.
• Off: Shift the ON/OFF switch slider to "O" position.
Changing a Sanding Sheet
The sanding sheet and sanding pad are provided with a hook
and loop attachment system to allow quick and easy changing
of sanding and polishing sheets.
NOTE Ensure the hook and loop surfaces of the tool plate,
and chosen sheet are as clean as possible, and free
from any large debris prior to mounting the sheet.
1. Baseplate
2. Friction plate cover
3. Switch push rod
4. Top cover with softgrip
5. Dust box
To attach a new sheet:
• Alight the edge of the disc with the edge of the pad,
and ensure the sheet is centered in the plate.
• Apply pressure to the disc, ensuring it is securely fixed
across the entire sanding pad.
To remove a disc:
• Lift one corner of the sanding disc and pull off from
the sanding pad.
Adjusting speed
• Disc speed can be varied by rotating the speed
adjustment wheel.
• The wheel allows fine control between minimum
(6,000 r/min) and maximum (14,000 r/min) speeds.
Publicidad
