Whittier Wood Products 176Wa Instrucciones De Montaje página 2

BEFORE BEGINNING ASSEMBLY, check that the quantities of the parts received match those on parts list below.
PART DESCRIPTION
AA Left Leg. . . . . . . . . . . . . . . . . . . . . . . 2
BB Right Leg . . . . . . . . . . . . . . . . . . . . . 2
CC Short Stretcher . . . . . . . . . . . . . . . . . 4
D Long Stretcher . . . . . . . . . . . . . . . . . 4
ASSEMBLY INSTRUCTIONS
USE A SLOW-DRYING EPOXY GLUE. ONCE YOU START GLUING THE
STOOL TOGETHER, CONTINUE UNTIL COMPLETE.
Before beginning assembly, lay out all the parts to become familiar with their location on the stool.
Note that there are two Left Legs and two Right Legs. When a leg is laying on its side with the two
upper holes facing up, the Left Leg will have the other two holes facing left and the Right Leg will
have the other two holes facing right. (See FIGURE 1.)
BB
Right Leg
FIG. 1
TO ASSEMBLE LEGS AND STRETCHERS:
NOTE: To make attachment of leg assembly to Seat easier, DO NOT insert Stretchers all the way into
the Legs. The shoulder should not be snug against the Leg. Allow approximately 1/4 inch of
the chuck to show. See FIGURE 1A.
1) Lay a Left Leg (AA) and a Right Leg (BB) so that the lower holes are facing each other. Apply an
even coat of glue to the holes that are facing each other. Insert a Short Stretcher (CC) into the up-
per holes and a Long Stretcher (D) into the lower holes. See FIGURE 1.
2) Repeat step 1 with the other pair of legs.
PAGE 2 — 173Wa/176Wa SP (Rev. 1/07)
173Wa & 176Wa Café Stools
TOOLS REQUIRED:
Hammer, rubber mallet, slow-drying two-part epoxy glue.
QTY.
IMPORTANT!
CC
D
PART DESCRIPTION
E Seat . . . . . . . . . . . . . . . . . . . . . . . . . 1
F #8 x 1 / " Black Screw . . . . . . . . . . . 4
5
8
G #8 x 1¼" Black Screw . . . . . . . . . . . . 8
AA
Left Leg
STRETCHER
FIG. 1A
Chuck
LEG
Shoulder
QTY.