Publicidad
Idiomas disponibles
Idiomas disponibles
FIG. 2
3) Apply an even coat of glue to the remaining four holes in each pair of legs. With one pair of legs
laying on its side, insert the Short Stretchers into the upper holes and the Long Stretchers into
the lower holes. Now take the other pair of legs and tap the stretchers into the proper holes (see
FIGURE 2). You have now completed the undercarriage assembly. Proceed to Step 4 without
delay.
HIGHER PAIR
D
CC
FIG. 3
TO ATTACH LEG ASSEMBLY TO SEAT
4) Apply an even coat of glue inside the four leg holes in the Seat (E). Insert the four legs into the
holes in the Seat and tap them firmly into place. Tap Stretchers completely into the Legs after leg
assembly is attached to seat. After all legs are in place, set the stool on a hard flat surface to make
sure that the legs are even, and the stool does not wobble. If the stool does wobble, determine
which two legs seem to be short (they will be diagonally across from each other). Turn the stool
over and pull these legs toward each other. Check to see if the wobble has been corrected. Repeat
this step until stool sits level. Allow the glue to set 4 to 6 hours.
5) For added strength, screw a #8 x 1
screws must be inserted at such an angle so that they do not go through the other side of the leg
or top of the seat. Screw a #8 x 1¼" Black Screw (G) through both ends of the four Long Stretch-
ers (D) into the legs. Insert the screws into the slightly higher pair of Long Stretchers first. The
screws must be inserted at such an angle so that they do not go through the other side of the leg.
See FIGURE 4A. No Screws are required for the Short Stretchers (CC).
CC
AA
BB
FIG. 4A
E
/
" Black Screw (F) through each leg chuck into the seat. The
5
8
D
AA or
BB
FIG. 4
173Wa/176Wa SP (Rev. 1/07) — PAGE 3
G
D
To insert screw at proper angle, the screw
head should be approximately 1/2" from the
nearest surface when starting the screw.
Insert the screws into the slightly higher
pair of Long Stretchers first.
F
E
Publicidad
