Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Prior to machine operation, pre-sweep floor to
remove debris before using the unit.
1.
Fill the freshwater tank with
cleaning solution at a maximum
temperature of 104°F (40°C).
Add cleaning solution per
manufacturer's recommendations.
2.
Press the red foot pedal lightly
with your foot and pull handle back
to start the motor. The brushes
and the drum will begin to rotate.
Pulling the handle towards you
WITHOUT pressing the pedal
lowers the machine and engages
the rotating brushes with the floor.
To stop working, return the handle
to the upright and locked position.
3.
Move forward while sparingly
pushing the solution control button.
This button should only be pushed
intermittently based on the floor
type and amount of soil on the floor.
For tiled or stone floors apply very
little solution. Release the solution
control button to stop the solution
discharge approximately 12 inches
before end of forward motion.
Continue to move forward up to the
wall without pressing button.
4.
Pull the machine backwards in the
same track WITHOUT discharging
any solution. When you reach the
starting point, change the track and
repeat the steps above. When you
are changing the track, allow some
overlap with the cleaned area to
ensure complete coverage. In case
of large halls, make a U-turn while
moving forward. If quick drying is
required, move on the same track
without discharging solution.
troubleshooting section in the back of this instruction manual.
18
OPERATION
Should the machine fail to operate, please refer to the
If the problem/remedy is not listed, please contact the
Tornado Technical Service Department
19
Publicidad
