Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROLS
Brush Controls:
Move the slider all the way UP to put
the machine in WORKING MODE. In
this mode, the brushes contact the
floor when the handle is moved to the
working position.
Keeping slider in the UP, working position while transporting the
machine WILL damage the brushes.
Always transport in TRANSPORT MODE.
Solution Control:
By pushing the red solution button, the
cleaning solution is sprayed onto the
floor from the front of the machine. The
solution stops once the solution control
button is released.
Brush Contact Control:
Brush contact control is adjustable in 4
steps in order to compensate for brush
wear and control scrubbing effect.
Contact is MINIMUM when the knob is
fully down and MAXIMUM when fully
raised. If the machine does not move
when the handle is lowered, slide the
brush contact control slider up one step.
Circuit Breaker:
In the event of circuit overload due to
improper power supply or unexpected
obstruction to the brush/drum
rotation, the circuit breaker trips and
protects the motor from damage. If
this happens, UNPLUG THE UNIT,
identify the cause, correct it, and
reset the breaker after a minimum of
1 minute from tripping by pressing
the circuit breaker button manually
and continue working as normal.
If no obstruction can be found,
consult a qualified electrician as the
source circuit could be potentially
problematic.
On / Off Control:
To start the motor, depress the red
pedal with your foot and pull handle
back. The brushes and the drum will
begin to rotate. Release the red foot
pedal in this position and pull handle
towards you in order to engage
rotating brushes onto the floor. To stop
operation, return the handle to the
upright and locked position.
16
CONTROLS
17
Publicidad
