Hupfer BTH/60-60 Manual De Instrucciones página 41

Transport, Putting into Operation and Decommissioning
Transport
4 Transport, Putting into Operation and Decommissioning
4.1 Transport
ATTENTION
The Mobile Cutlery Soak Sink is delivered as an assembled unit, i.e. it is completely assembled including the
heating.
When loading, use only hoists and load lifting devices approved for the weight of the Mobile Cutlery Soak
Sink. Only the transport vehicles may be used that are approved for the weight of the appliance.
According to the valid purchase contract, the scope of delivery is specified in the shipping documents at-
tached to the delivery item.
4.2 Putting into Operation
DANGER
Remove the original packing and check, whether the appliance is complete and undamaged. In no case put
a defective appliance into operation and inform the supplier immediately.
Always place the Mobile Cutlery Soak Sink on firm and level floors when unpacking and operating it. Apply
the total brakes on both swivel casters to secure the appliance against rolling away.
INFO
The Mobile Cutlery Soak Sink should be thoroughly cleaned with a soft cloth before putting it into operation
for the first time. Before the appliance is put into operation it must be clean and dry.
The following appliance functions must be checked before putting it into operation:
the function of the total brakes
the function of the operating elements and heating.
4330030_A1
All manuals and user guides at all-guides.com
Appliance damages caused by improper transport
In the case of off-site transport in a vehicle such as a lorry, the appliances
should be secured properly. The total brakes are not sufficient as a transport
securing method.
If the appliances are not secured properly, there is a risk of damage to prop-
erty and persons caused by squashing.
During transport, secure all the individually standing appliances using corre-
sponding transport securing devices.
Hazardous electrical voltage
The electrical voltage may be considerably dangerous to limb and life of per-
sons and lead to injuries.
Before putting the appliance into operation check, whether the power supply
indicated on the rating plate (230V / 50 Hz) corresponds to the local power
supply. Otherwise, do not put the appliance into operation.
Do not use any extension leads in wet areas.
Disposal of packing material
The packing consists of recyclable materials and can be disposed of appro-
priately. Thereby, the different materials are to be separated and disposed in
an environmentally compatible manner. In any case, the local bodies respon-
sible for disposal are to be involved for this purpose.
Chapter 4
Page 15
Mobile Cutlery Soak Sink
BTH/60-60