KLASS Fan TORNADO LT Manual De Instrucciones página 23

7
decorative cover
- Remove the screws which are on the
screw M8
motor.
- Do not touch the fan, let it static, then
screw
hold the down rod, fasten the two M8
cross pin firmly.
motor
- Fix the decorative cover to the motor
by the removed screws.
- Install the small decorative piece
decorative piece
to the decorative cover, adjust it and
screw
gap
cover the gap.
8 A - With light
- Remove one screw from the motor
round piece, unscrew the other two
screws out by 3-4mm.
- Attach the light kit to the fan, fix the
first screw back to the hole and tighten
all the three screws firmly.
- Direct plug the wire to the lightkit
docking (connector).
- Attach the lamp cover to the lightkit
and twist clockwise until it is secured
tightly.
21