Publicidad
Idiomas disponibles
Idiomas disponibles
Crivit CEK 29 B4
7.3 Switching the Cool Box On and Off
7.3.1 12 V Mode
WARNING! You must ensure that your vehicle has a 12 V
in-car electrical system. The cool box must not be put into
operation with a 24 V in-car electrical system.
Take the connecting cable with cigarette lighter socket connection [1] out of the cable box [3].
Unwind the connecting cable fully. Set the operating mode selection switch [6] to 'COLD' for
cooling food or 'HOT' to keep food warm. Now plug the cigarette lighter socket connection [1]
into a suitable cigarette lighter socket in your vehicle. The cool box is now switched on. To switch
off the cool box, remove the cigarette lighter socket connection [1] from the cigarette lighter socket
in your vehicle.
The output controller [7] on the front of the cool box does not function in 12 V mode. The cool
box operates at maximum output. An interior temperature that is at most 20°C cooler than the
ambient temperature can be achieved (based on an ambient temperature of 23°C). In
warming mode, an interior temperature no higher than 65 °C can be achieved (based on an
ambient temperature of 23°C).
As cigarette lighter sockets in some vehicles still provide power when the ignition is switched
off, the cigarette lighter socket connection [1] should always be disconnected from the
cigarette lighter socket when leaving your vehicle. Otherwise this could significantly drain your
vehicle's battery and therefore prevent the engine from starting up again.
To prevent items in the cool box from freezing, do not use the cool box in 12 V cooling mode
below an ambient temperature of 18°C.
7.3.2 230 V Mode
Remove the connection cable with the mains plug [8] from the cable box [4]. Unwind the
connection cable completely. Plug the mains plug [8] into an easily accessible mains socket. Set the
operating mode selector switch [6] to "COLD" to keep food cold or "HOT" to keep it warm. Turn
the power adjustment knob [7] on the front of the coolbox clockwise to the ECO position to switch
the coolbox on. Set the power you want using the power adjustment knob [7]. Turn the power
adjustment knob [7] clockwise to increase the power and anticlockwise to reduce the power.
In cooling mode, turn the output controller [7] to the 'MAX' position to obtain maximum cooling. An
interior temperature that is at most 20°C cooler than the ambient temperature can be achieved
(based on an ambient temperature of 23°C).
In warming mode, turn the output controller [7] to the 'MAX' position to obtain maximum warming.
An interior temperature no higher than about 65 °C can be achieved (based on an ambient
temperature of 23°C).
34 - English
Publicidad
