Publicidad
Idiomas disponibles
Idiomas disponibles
Variant: Automatic brush lowering (Option ULTIMAXX
Premium)
• Press the Brush drive button ON/
OFF.
The display lights up and the brush
unit is stopped and lifted.
• Drive on for a few meters in order to absorb the remaining
drain water.
Variant: Foot pedal
• To lift the tool, push the foot pedal
downwards until it engages.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Lift the suction nozzle.
Allow the suction unit to run on so
that the remaining waste water in the
hose is sucked up.
• Press the Suction unit ON/OFF but-
ton.
The display lights up; the suction en-
gine stops.
• Switch off the machine.
Caution:
The machine must now be emptied and cleaned.
Switch off the machine (remove key) and remove
the plug from the mains socket.
Removing and cleaning the suction nozzle
• Pull the suction hose from the connector.
• Lift the suction nozzle with your foot.
• Compress the lock springs. The suc-
tion nozzle is released and can be re-
moved from the squeegee holder.
• Clean the suction nozzle under running water using a
brush.
Notice:
Only cleaned and intact blades ensure optimal suc-
tion results!
Empty and clean the recovery tank and fresh
water tank
Notice:
Drain water or cleaning solution must be disposed
of in compliance with the national regulations.
Notice:
When draining the recovery tank, the regulations of
the detergent supplier regarding personal protec-
tive equipment of the cleaning solution manufactur-
er must be observed.
Proceed as follows:
• Take the drain hose out of the holder.
• Open the red or blue cover at the level of the handle, lower
the end of the hose slowly and empty the recovery or fresh
water tank.
Cleaning the recovery tank and fresh water tank
• Swivel the folding stand out of the holder and place it into
the tank recess.
• Rinse the recovery tank and the fresh water tank thorough-
ly with clean water.
• Remove the dirt sieve (yellow), emp-
ty it and thoroughly rinse it under run-
ning water.
• Take out the suction filter (yellow)
and remove the dirt with a cloth or a
soft brush.
• Check the float to make sure it is fully
functional and repair any fault
• After you have finished emptying the tanks, close the red
and blue cover back on and hang the hoses on the holder.
• Reassemble the dirt sieve (yellow) and the suction filter.
Caution:
Clogged suction filters may impair the suction per-
formance.
Cleaning the fresh water tank filter
Caution:
Clean the fresh water tank filter after the end of op-
eration.
Clogged filters can inhibit the supply of detergents and
thus lead to surface damage.
• The machine must be switched off.
• Unscrew the fresh water tank filter
and remove it.
• Rinse the filter thoroughly with clean
water.
115
Publicidad
