VONROC PW509AC Traducción Del Manual Original página 8

EN
TECHNICAL SPECIFICATIONS
Model No.
Voltage
Input power
Max. pressure water supply
Max. water temperature
Rated flow rate
Max. flow rate
Rated pressure
Max. pressure
Weight
IP class
Protective class
Lpa (sound pressure)
Lwa (sound power)
Max. LwA (sound power)
Vibration
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-4.
1. High pressure cleaner
2. On/off switch
3. Water inlet filter
4. Hose reel
5. Hose reel handle
6. Gun holder
7. Handle
8. Cable holder
9. Spray gun
10. Adjustable spray lance
11. Turbo lance
12. Lance extension
13. Cleaning needle
14. Detergent tank
15. Patio cleaner
16. High pressure hose
17. Detergent adjustment
18. Nozzle holder
19. Adapter from thread to quick connector
8
PW509AC
220-240 V~ 50Hz
2500 W
12 bar
50 °C
7 l/min
7.8 l/min
130 bar
195 bar
21 kg
IPX5
II
72.5 dB(A) K=3dB(A)
86.2 dB(A) K=3dB(A)
86 dB(A)
0.933 m/s
2
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Assembly of the gun holder, cable holder and
nozzle holder (Fig. A, B)
Assemble gun holder (6), cable holder (8) and
nozzle holder (18) as shown in Fig. B.
Hose reel handle (Fig. A)
Push the hose reel handle (5) through the hole of
the handle holder until it clicks. The hose reel (4) is
now ready for use.
4. OPERATION
The machine may cause electrical
disturbances when starting.
The motor of this pressure washer will NOT
run. It will only operate when the trigger is
squeezed.
The cleaner must only be used with clean
water; use of unfiltered water or corrosive
chemicals will damage the cleaner.
If the motor stops and fails to restart, wait
2-3 minutes before restarting. THERMAL
CUTOUT TRIPPED.
Turning on (Fig. A, C)
1. Turn the switch (2) to the "OFF/0" position.
2. Ensure that you have a suitable water supply to
feed the pressure washer.
3. Connect lance (10 / 11) as shown in Fig. C1.
4. Connect the spray gun (9) to the high pressure
hose (16) as shown in Fig. C2.
5. Check gauze filter (3) is clear of any blockage and
assemble on the machine as shown in Fig. C3.
6. Connect the water supply hose.
7. Check that the hose has no kinks in it.
8. Turn on water and check for leaks.
9. Squeeze trigger to allow air to be expelled
though the pump and hoses, lock trigger as
shown in Fig. C4.
10. Plug in machine and turn on switch (2).
11. Unlock trigger as shown in Fig. C4 and use the
pressure washer.
WWW.VONROC.COM