Wesco WS2539 Manual Del Usuario página 32

full or no less than half charge before
storage. If the tool will not be used
for long periods of time, charge the
battery every 3-6 months.
C)HARGING PROCEDURE
1) Plug the charger into an
appropriate outlet.
2) Place the battery pack into the
charger
3) When charging is completed,
unplug the charger and remove the
battery pack.
WARNING:
When battery charge runs out
after continuous use or exposure to
direct sunlight or heat, allow time
for the battery to cool down before
recharging to achieve the full charge.
D) CHARGING INDICATOR
Light On/off
Red on
Green
on
2. TO REMOVE OR INSTALL BATTERY
PACK (SEE FIG. A2, A3)
Depress the Battery Pack Release
Button to release and slide the
Battery Pack out from your tool. After
recharge, Slide it back into your tool.
A simple push and slight pressure will
be sufficient.
ASSEMBLY
WARNING: Always turn off mini drill
before changing accessories, changing
collets, or servicing the tool.
32
Status
Charging
Fully Charged
1. FITTING AN ACCESSORY (SEE B)
Keep the spindle lock button depressed. Use the
spanner to slacken the collet nut. Then insert the
shaft of the accessory into the collet nut.
Use the spanner to lightly tighten the collet nut
(do not over tighten).
WARNING: Do not engage the spindle
lock button while mini drill is running.
2. REPLACING THE COLLET (SEE C)
When using an accessory with a smaller or larger
shaft, i.e.: drills, you will need to change the
collet as detailed below:
Keep the spindle lock button depressed. Use the
spanner to slacken the collet nut. Then remove
the collet nut and old collet and locate the new
collet. Afterwards restore the collet nut. Finally
release the spindle lock button.
Caution: Always use the collet which matches the
shank size of the accessory you plan to use. Do
not force a larger diameter shank into a smaller
collet.
3. FITTING A CUTTING/SANDING
WHEEL (SEE FIG D, E)
Use the cutting wheel fixture (13).
First locate mandrel as detailed earlier. Then
unscrew small screw on top of wheel fixture.
Insert screw through wheel and screw into
mandre. Do not over tighten, otherwise the wheel
may crack.
Caution: Always hold the tool away from your
face. Accessories can be damaged during
handling and can fly apart as they come up to
speed.
OPERATION
1. ON/OFF SWITCH AND DECREASE/
INCREASE SPEED SELECTOR
(SEE FIG F1-F3)
Note: If the On/Off Switch is not at "0" position,
please dial the On/Off Switch to "0"position (See
Fig.F1).
Dial the On/Off Switch from "0" position to "2"
position, the tool will start to work. (See Fig.F2)
Continue to Dial the switch to a higher mark, the
EN