Troubleshooting - POLTI VAPORETTO SMART 100 Manual De Instrucciones

16. TROUBLESHOOTING

PROBLEM
The appliance does not turn on.
The steam ready indicator light
turns on and off during use.
Does not dispense steam.
The appliance is pressurised
but little steam comes out.
Floors that are too wet.
Accessories are difficult to as-
semble.
If problems persist or are not listed above, please contact our Polti Customer Services.
USA: 1-888-99-POLTI (1-888-997-6584)
Monday - Friday: 8am - 6pm EST
CAUSE
No power.
This indicates that the
electrical resistor has star-
ted to work to keep the
pressure constant
Out of water.
Steam lock activated.
The boiler is not
pressurised.
Steam hose trapped or
twisted.
Steam adjustment dial set
to the Minimum level.
First delivery of steam or
after approx. two minutes
of inactivity.
Steam level too high.
Room temperature
cold.
The seals produce friction.
| 16 |
SOLUTION
Check that the appliance has
been connected to the mains, as
indicated in Section 1.
It is a normal phenomenon, no
action is necessary.
Add water to the boiler as
described in Section 11.
Deactivate the steam lock on the
handle.
yet Wait until the steam indicator
light comes on.
Check that the steam hose is not
trapped or twisted.
Adjust the position of the dial for
the desired increase.
Direct the steam jet onto a cloth
for a few seconds.
Reduce the quantity of steam.
too Reduce the quantity of steam
and dispense intermittently.
Lubricate the seals with silicone
grease or
alternatively with a small amount
of vegetable oil.
Vaseline, or