Installation Instructions - urmet domus 1092 Manual De Usuario

ACCESSORIES
•
N°1 support bracket for the housing.
•
N°2 PG fairleads.
•
N°2 fixing screws (of different sizes) for camera. Use the most suitable screw, according to the
camera.
•
N°1 additional bracket for fixing the camera. Use the most suitable fixing bracket according to the
camera).
•
N°1 rubber o-ring
•
N°6 contersunk screws.
•
N°1 Allen wrench.
•
User manual.
Important note:
PG fairleads can be used to pass through circular section wires with a diameter in the range from 5 to
13mm.

INSTALLATION INSTRUCTIONS

•
Arrange a suitable circuit breaker and fuse upstream of the devices.
•
Make sure that the rating plate data corresponds to the power specifications before connecting the
device to the mains.
•
If the device falls or is damaged in any way, avoid to use it. Contact the authorized technical service
centre before activating it again.
INSTALLATION
•
Make sure that no units are powered before starting the installation procedure.
•
Make sure that the rating plate data correspond to the power specifications before connecting the
device to the mains.
•
Install the power supply cables according to standard safety regulations.
•
Identify the point which meets all the correct installation requirements and drill the four racket
fastening holes. Use suitable fastening devices according to the wall type and capable of supporting a
load of at least 5 Kg.
•
Fix the bracket to the wall. To make the housing installation easier, it is suggested to place and block
the articulated joint of the fixing bracket in a vertical position. For its adjustment, tighten the respective
screw using the provided allen spanner. (*)
Important note:
(*) The bracket is designed for cable passage also through the wall mounting base. If this solution has been
chosen, remove with pliers the pre-punched parts present on the bracket wall mounting base.
•
Fix the two provided cable ties to the housing; they must match with the two holes on the housing
bottom.
•
Fix the housing to the bracket using the provided countersunk head screws and the rubber o-ring.
DS1092-061A
7