Cleaning The Device - urmet domus 1092 Manual De Usuario

•
Place the video signal RG cable inside the housing, passing it through one of the two holes present
on the housing and provided with a cable gland and connect the cable to the camera (*)
Put the power supply cable inside the housing, passing it through the second hole present on the
housing and provided with a cable gland and connect the cable to the IN terminal block on the printed
circuit, according to the terminal pin silk-screen. (*)
Important note:
(*) Use both the holes with cable glands to insert the cables in the housing; one is dedicated to power
supply only and the other one to video signal and data. All the power supply cable length inside the bracket
must be provided with double insulation.
•
Using the adjusting and fixing screw of the articulated joint, orientate and fix the housing according to
the images to be captured.
•
Perform focusing operations following the installed camera and lens instruction manual. Once the
adjusting operations has been performed, reassemble the housing, taking care to:
Tighten the PG fairlead rings.
Screw the two closing screws of the housing.

CLEANING THE DEVICE

Disconnect all electrical parts from the mains before cleaning.
Rub delicately with a dry cloth to remove dust and dirt.
Dip the cloth in neutral detergent if dirt cannot be eliminated with a dry cloth alone.
Do not use volatile liquids (such a petrol, alcohol, solvents, etc.) or chemically treated clothes to clean the
devices to prevent deformation, deterioration or scratches to the paint finish.
DS1092-061A
9