EFFEKTIV TRIUMPHATOR 2000X Manual De Usuario página 15

FINISHING THE SEAM
To achieve the best results, use a piece
of scrap fabric at the beginning and end
of the seam.
Beginning of the Seam
A. Raise the presser foot and insert a piece
of scrap fabric under the foot. Lower the
foot and turn the balance wheel several
times toward you.
Step on the foot controller and start
sewing slowly.
B. Stop sewing at the end of the scrap
fabric.Insert the main fabric after the
scrap as shown, then start sewing on the
main fabric.
End of the Seam
C. Stop sewing at the end of the main
fabric. Insert another piece of scrap fabric
after the main fabric as shown, then sew
through the scrap.
D. Cut the connecting threads between the
main fabric and scrap fabric.
28
Balance wheel

Scrap fabric

Main fabric

Another scrap fabric

Connecting threads

EN USER MANUAL
TRIUMPHATOR 2000X
Knotting the Threads
Draw the needle threads to the wrong side
of the fabric by using a pair of tweezers
and knot them together.
Removing the Fabric in the Middle of
the Stitching
1. Raise the needles to their highest
position by turning the balance wheel
toward you.
Balance wheel

2. Raise the presser foot with the
presser foot lifter.
Presser foot lifter.

3. Pull the needle threads before the
needle eyes. This prevents the
threads from being caught when
removing the fabric.
4. Pull the fabric to the rear.
5. Remove the fabric and cut threads
with the thread cutter.
Thread cutter

29