Publicidad
Idiomas disponibles
Idiomas disponibles
SYMBOLS
To reduce the risk of injury, user must read
instruction manual
Wear ear protection
Wear eye protection
Wear dust mask
Do not dispose of batteries, Return exhausted
batteries to your local collection or recycling
point.
Do not expose to rain or water
Do not burn
For indoor use only
Double insulation
The output plug is with positive center pole and
negative outer pole
16
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The power tool is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
1.BEFORE OPERATING THIS TOOL
A) CHARGE THE BATTERY
The battery charger supplied is only for the Li-ion battery
installed in the machine. Do not use another battery
charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the machine is switched off
by means of a protective circuit: The tool holder no longer
rotates.
When the Battery Pack is charged for the first time or
after prolonged storage, the Battery Pack will accept a
100% charge after several charge and discharge cycles.
B) CHARGING (See Fig. A)
Plug the charger plug into a suitable power outlet.
Next, connect the charger to the Charging Socket on
the screwdriver; the indicator will illuminate Red during
charging.
Let the battery charge for 3-5 hours. The battery is fully
charged as soon as the indicator is no longer lit. Then
unplug the charger. Disconnect the Charger from the
screwdriver. The screwdriver is ready to be used.
Important:
When charging, the charger and screwdriver may become
warm to the touch; this is normal and does not indicate
a problem.
2. OPERATING INSTRUCTIONS
Inspect the Screwdriver before using to ensure all the parts
are running smoothly and there are no abnormal sounds
or sparks. Before driving fasteners, check behind walls for
wire and other electrical hazards or plumbing.
OPERATION
1. FITTING AND REMOVING BITS (See Fig. B)
Insert the bit into the Chuck(4) and push the bit into the
chuck as far as possible. To
remove the bit, simply pull it out of the Chuck(4).
WARNING: Do not suggest to use
screw bit shorter then 25mm. When
insert into the bit holder, it is difficult to pull it
out.
EN
Publicidad
