Publicidad
Idiomas disponibles
Idiomas disponibles
non-ferrous metals.
When cutting thin gauge sheet metals, ALWAYS clamp
wood on both sides of the sheet. This will give you a clean
cut without excess vibration or tearing of the metal.
DO NOT force the cutting blade. Forcing the blade will
reduce blade life and cause the blade to break.
NOTE: We recommend that you spread a thin film of oil
or other coolant along the line of cut ahead of the saw. This
will allow easier operation and help extend blade life. When
cutting aluminum, use kerosene.
6. DISPOSAL OF AN EXHAUSTED BATTERY
PACK
To preserve natural resources, please recycle or
dispose of the battery pack properly. This battery
pack contains Li-ion batteries. Consult your local
waste authority for information regarding available recycling
and/or disposal options. Discharge your battery pack by
operating your saw, then remove the battery pack from the
saw housing and cover the battery pack connections with
heavy duty adhesive tape to prevent short circuit and energy
discharge. Do not attempt to open or remove any of the
components.
WORKING HINTS FOR
YOUR CORDLESS
RECIPROCATING SAW
Always use a blade suited to the material and material
thickness to be cut. The quality of cut will improve as the
number of blade teeth increase. Always ensure the work-
piece is firmly held or clamped to prevent movement.
Support large panels close to the cut line. Any movement
of the material may affect the quality of the cut. The blade
cuts on the upward stroke and may chip the uppermost
surface or edges of your work piece when cutting, ensure
your uppermost surface is a non-visible surface when your
work is finished.
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
EN
Keep all working controls free of dust. Occasionally you may
see sparks through the ventilation slots. This is normal and
will not damage your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage of
tool and battery is 0°C-45°C.
The recommended ambient temperature range for the
charging system during charging is 0°C-40°C
19
Publicidad
