Wesco WS2972 Manual De Instrucciones página 19

OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
NOTE:
a) Do not use any charger other than that specifically
provided for use with the equipment.
b) If the battery pack is very hot you must remove your
battery pack from the charger and allow time for the
battery to cool down before recharging.
c) The battery in your new tool is not charged when it
leaves the plant. Therefore it must be full charged before
using the first time
d) Please charge the battery to reach full or no less than
half charge before storage. If the tool will not be used for
long periods of time, charge the battery every 3-6 months
Charging procedure.
CHARGING PROCEDURE (SEE FIG. A)
1)Plug the charger into an appropriate outlet. The light
will be green.
2)Slide the battery pack into the charger, the light will
turn to red to indicate the charging process has started.
3)When charging is completed, the light will turn to green.
The pack is now fully charged, unplug the charger and
remove the battery pack.
WARNING: When battery charge runs
out after continuously use or exposure
to direct sunlight or heat, allow time for the
tool to cool down before re-charging to
achieve the full charge.
CHARGING INDICATOR
Light
Red ON
Green ON
B) TO REMOVE AND INSTALL THE BATTERY
PACK (SEE FIG. B)
Depress the Battery Pack Release Button firmly first and
then slide the Battery Pack out from your tool to remove
the battery pack. After recharge, insert the battery pack
EN
Status
Charging
Fully charged
into the tool's battery port. A simple push and slight
pressure will be sufficient.
OPERATION
1. ON / OFF SWITCH (SEE FIG. C)
Depress the On/Off switch to start and release it to stop
your drill. The on/off switch is fitted with a brake function
which stops your chuck immediately when you quickly
release the switch.
It is also a variable speed switch that delivers higher
speed and torque with increased trigger pressure. Speed
is controlled by the amount of switch trigger depression.
WARNING: Do not operate for long
periods at low speed because excess
heat will be produced internally.When
overload occurs, release the on/off switch
immediately to avoid the motor overheating.
2. SWITCH LOCK (SEE FIG. C)
The switch trigger can be locked in the OFF position. This
helps to reduce the possibility of accidental starting when
not in use. To lock the switch trigger, place the rotation
control in the center position.
3. REVERSIBLE (SEE FIG. D1, D2)
For drilling and screw driving use forward rotation
marked" " (lever is moved to the left). Only use
reverse rotation marked"
right) to remove screws or release a jammed drill bit.
WARNING: Never change the direction
of rotation when the chuck is rotating,
wait until it has stopped!
4. CHUCK ADJUSTMENT (SEE FIG. E)
To open the chuck jaws rotate the front section of the
chuck. Insert the drill bit between the chuck jaws and
rotate the front section in the opposite direction. Ensure
the drill bit is in the center of the chuck jaws. Finally,
firmly rotate the front chuck section in the opposite
directions. Your drill bit is now clamped in the chuck.
5. TORQUE ADJUSTMENT (SEE FIG. F)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment
ring. The torque is greater when the torque adjustment
ring is set on a higher setting. The torque is less when the
torque adjustment ring is set on a lower setting.
Make the setting as follows:
1 - 4 For driving small screws
5 - 9 For driving screws into soft material
" (lever is moved to the
19