Bostitch BTCN560 Traducido De Las Instrucciones Originales página 46

EnGLIsh
SYMPTOM CAUSE
Tool does not Dry fire lock out engaged,
actuate (motor blocking contact trip from
runs but will not traveling fully
fire)
Low battery charge or
damaged battery
Jammed nail/drive blade not
returned to home position
Damaged driver/return
assembly
Jammed internal mechanism See authorised Bostitch repair agent.
Damaged internal
electronics
Motor starts up Jammed nail and driver
but generates a blade is stuck in down
lot of noise position
Damaged driver/return
assembly
Drive blade Jammed nail and driver
continues to get blade is stuck in down
stuck in down position
position
Damaged driver/return
assembly
Material and fastener length
Tool is not yet run-in
Use of incorrect speed
Debris in nosepiece
Tool operates Depth adjust set too shallow Rotate depth adjust to a deeper setting.
but does not
Tool not firmly applied to
drive fasteners
workpiece
fully
Bump mode selected with
long nails (BTCN560 only)
Material and fastener length
Damaged or worn driver
blade tip
Tool used with non-mar tip
Tool is not yet run-in
Use of incorrect speed
Damaged actuation
mechanism
44
FIX
Load nails into magazine.
Check charge level if pack shows state-of-charge. Charge or replace battery
pack if necessary.
Remove battery, clear jammed nail, cycle stall release lever, (push driver blade
up manually if necessary) reinsert battery pack.
Replace driver/return assembly. See authorised Bostitch repair agent.
See authorised Bostitch repair agent.
Use stall release lever, clear any jammed nails, and return driver blade manually
if necessary.
Replace driver/return assembly. See authorised Bostitch repair agent.
Use stall release lever, clear and jammed nails, and return driver blade manually
if necessary.
Replace driver/return assembly. See authorised Bostitch repair agent.
If the unit continues to stall (forcing the need to rotate the Stall release lever)
choose the appropriate material and fastener length that is not too rigorous
an application.
New tools can take 500–1000 nails for parts to mesh and wear in together.
Drive shorter nails during this period if experiencing difficulty driving nails flush.
If trying to drive longer ring shank nails in soft woods, or driving ring shank nails
into harder materials in speed 1–adjust speed setting to position 2.
Clean nose area and watch closely for small pieces of broken nails stuck in
the track.
Apply adequate force to tool securing it tightly to workpiece. Refer to
instruction manual.
Select sequential mode.
If the unit continues to stall (forcing the need to rotate the Stall release lever)
choose the appropriate material and fastener length that is not too rigorous of
an application.
Replace driver/return assembly. See authorised Bostitch repair agent.
Remove non-mar tip.
New tools can take 500–1000 nails for parts to mesh and wear in together.
Drive shorter nails during this period if experiencing difficulty driving nails flush.
If trying to drive longer ring shank nails in soft woods, or driving ring shank nails
into harder materials in speed 1–adjust speed setting to position 2.
See authorised Bostitch repair agent.