Publicidad
Agitator Support
Support de l'agitateur
Soportes del agitador
Removing Belt
➢ ➢ Disconnect cleaner from electrical
➢ ➢ Check and remove hair, string and
➢ ➢ If build-up becomes excessive,
Tab
➢ ➢ Remove light cover and light bulb
Languette
Pestaña
➢ ➢ Unscrew the two (2) POWER
➢ ➢ Turn POWER NOZZLE over.
➢ ➢ To remove cover, insert screwdriver
➢ ➢ Turn POWER NOZZLE right side up.
Base
➢ ➢ Press handle release pedal and
➢ ➢ Tilt cover forward from back until
➢ ➢ Carefully insert and twist
➢ ➢ Remove worn belt.
➢ ➢ See AGITATOR ASSEMBLY for picture
- 36 -
outlet.
lint build-up frequently in
the POWER NOZZLE brush and brush
support areas.
disconnect POWER NOZZLE
from wand and follow the steps
below.
as shown under "REPLACING
HEADLIGHT BULB".
NOZZLE cover screws .
at cover tabs on both sides
and twist to release tabs.
lower the swivel.
front snaps free.
screwdriver at each brush support
to free brush from base.
of complete brush assembly.
Publicidad
