Publicidad
Idiomas disponibles
Idiomas disponibles
Vibrating mopping mode
When mopping, the vibrating mopping mode is enabled by default to enhance
the mopping effect, and can better remove water stains compared with the
standard mopping mode. This mode can be disabled in the app. Once disabled,
the vacuum-mop will switch to the standard mopping mode.
When the vacuum-mop is working, press any button to pause it, and press the
button
to resume the cleaning. Press the button
cleaning and send the vacuum-mop back to the charging dock.
Sleep mode
The vacuum-mop will automatically enter the sleep mode if it does not work
or be operated for more than 5 minutes in the non-charging state. Press any
button or use the app to wake it up. The vacuum-mop will automatically turn
off if it is in sleep mode for more than 6 hours.
enter sleep mode while on the charging dock.
Adding water or cleaning mop pad during cleanup
If you need to add more water to the water tank or clean the mop pad during a
cleaning task, press any button to pause the vacuum-mop. Then you can remove
the water tank to add water or clean the mop pad. After adding water or cleaning
the mop pad, reinstall the water tank and mop pad, and press the button
resume the cleaning.
Returning to the dock to charge
Resetting/Restoring the system
To reset the system: Use a pin to press and hold the reset button for 3 seconds
until you hear a voice saying "System reset successfully". Then the vacuum-mop
will automatically restart, and the settings such as scheduled cleanup and Wi-Fi
connection will be restored to their original factory settings.
Pausing
to end the current
Note: The vacuum-mop will not
to
When the vacuum-mop is on, press the button
the charging dock to charge. The vacuum-mop will automatically return to the
dock after finishing a cleaning task, and the indicator will blink white. If the
vacuum-mop starts running low on battery while cleaning, it will automatically
return to the dock to charge and resume the cleaning where it left off once it is
fully charged.
Resuming the cleanup
The vacuum-mop has the feature of resuming the cleanup. If the vacuum-mop
starts running low on battery during a cleaning task, it will automatically return to
the charging dock to charge. Once the vacuum-mop is fully charged, it will
resume the cleanup where it left off. If the cleanup is manually ended or if you
move or operate the vacuum-mop when it is being charged or returning to the
charging dock, the cleanup will not be resumed.
Resetting Wi-Fi
When switching to a new router or changing your Wi-Fi password, you will need
to reset the vacuum-mop's Wi-Fi connection. To do so, turn on the vacuum-mop,
then simultaneously press and hold the buttons
you hear a voice saying "Resetting the Wi-Fi connection and entering network
configuration mode". Once the Wi-Fi connection is reset, you can reconnect the
vacuum-mop.
Note: Only 2.4 GHz Wi-Fi networks are supported.
Cleaning up all areas
If you choose to clean up all areas when no map is saved, the vacuum-mop will
clean square-shaped areas of 6 × 6 meters one by one. After a map has been
saved in the app and you select to clean up all areas, the vacuum-mop will
automatically clean each room according to the planned route. And it will return
to the charging dock after the cleaning is completed.
To restore the system to the previous firmware version: Use a pin to press and
hold the reset button for 10 seconds until you hear a voice saying "System
restored successfully". Then the vacuum-mop will automatically restart, and the
settings such as scheduled cleanup and Wi-Fi connection will be restored to their
original factory settings.
11
to send the vacuum-mop to
and
for 7 seconds until
Publicidad
