Publicidad
Idiomas disponibles
Idiomas disponibles
Follow configuring the heating supply angle. Use selection arrows
desired angle and confirm with a short press on the
Quit parameter configuration at any moment by pressing
• Zone anti-freezing function activation, ANHI: This option prevents from a temperatura
drop below 12ºC even when the zone is not in use. This function is available for any
heating mode
not activate. By default this function is deactivated
icon, value will start blinking indicating it is modifiable. Use selection arrows
to select the desired value
Quit parameter configuration at any moment by pressing
• Control de etapas, ETAP: In the case of controlling air supply and radiant elements in
your zone, this option allows selecting with which you want acclimatize your zone, heat
and cold mode, Air (A), radiant element (R), combined (AR). This option is only
configurable for zones where both sources are available.
To configure the heating source for the zone, press on the
blinking indicating it is modifiable. Use selection arrows
and confirm with a short press on the
Quit parameter configuration at any moment by pressing
1P
• Webserver IP
connected. Press on the icon
to display the octects of the IP address. To quit press on
back to previous menu.
• Energy Efficiency eadp: Select the desired energy efficiency level among: Comfort (Cnf)
or Efficiency (efi). By default it is set to comfort. If you want to change it, press on the
icon
, the menu value will start blinking. Use selection arrows
to confirm. To quit press
. In case the system working mode is set to STOP
OM
and confirm with a short press on the
: Shows the local IP of the webserver to which the system is
OFF
. To activate it, press short on the
icon.
, menu value will start blinking. Use arrows
going back to previous menu.
to select the
icon.
icon.
, zone will
icon.
icon, value will start
to select the desired value
icon.
or press
and press
icon.
to go
51
Publicidad
