Descargar Imprimir esta página

Horizont farmer ABN30 Instrucciones De Servicio página 5

Ocultar thumbs Ver también para farmer ABN30:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
3. Entfernen Sie regelmäßig Ablagerungen und Schmutz vom Solarpanel.
Dies beinhaltet die Entfernung von Grasschnitt, Staub (speziell an Schotterwegen), Blättern und Schnee, da
dies die Leistung des Moduls zur Aufladung des Akkus reduzieren kann.
SERVICE:
Reparaturen dürfen nur von qualifizierten Personen durchgeführt werden.
Es sind nur die vom Hersteller vorgeschriebenen Ersatzbauteile zu verwenden.
Technische Änderungen vorbehalten!
Operating instruction for electric fence controller farmer
ABN30 & hotshock ABN37 & ranger ABN60
in connection with safety hints SECURA ANIMAL or
SECURA SECURITY(www.horizont.com/securaanimal or
www.horizont.com/securasecurity)
Energizer has to be turned OFF before any intervention!
ASSEMBLY AND CONNECTION:
Set the device up in as moist a location as possible. The supplied U earthing rod/
set-up post 14498 or the optional 1m earthing rod (longitudinal rod) 14041-1 must
be driven as deeply as possible into the ground in a damp area and connected with
a high voltage-resistant connecting cable (e.g. 90150) with the black earth terminal
(
) of the device (PG. 37/FIG.7). Connect the high voltage-resistant fence cable
(e.g. 90676U) to the red terminal with the lightning symbol ( ). The device is only
protected against moisture if it is properly assembled. Place the device on the U
earthing rod and do not operate it while it is lying on the ground. Set the device up
in a non fire-hazard location.
COMMISSIONING:
Switch the device on with the push-button switch (PG.38/
an LED lights up in the same rhythm as the impulses. The device transmits im-
pulses to the fence. If the LED does not light up, either the 9 volt battery or the 12
volt rechargeable battery is spent. It could also be a defect in the device or at the
230 volt mains adapter.
FARMER ABN30
The incorporated current saving circuit is self-regulating and consumes less energy
with a well insulated fence.
COMMISSIONING WITH OPTIONAL 9 VOLT DRY BATTERY
(PG. 35/FIG.3,4 & PG. 36/FIG.6):
(use only alkaline batteries)
Open the housing and insert the 9 volt battery. Then connect the device to the 9 V
battery (red + / black -), ensure correct polarity.
farmer ABN30 & hotshock ABN37 & ranger ABN60
/
RANGER ABN60:
) - after a few seconds
1
5

Publicidad

loading

Este manual también es adecuado para:

Hotshock abn37Ranger abn60108911089210983