Fiap LightFountain ACTIVE Instrucciones De Uso página 8

WATER FEATURES GB
LightFountain ACTIVE
All work with this device may only be carried out in accordance with these instructions.
The combination of water and electricity can lead to serious danger to life and limb if it
is not connected properly or handled improperly. Only operate the device when there are
no people in the water! Before reaching into the water, always pull out the mains plug of
all devices in the water. Compare the electrical data of the power supply with the type
plate on the packaging or on the device. Make sure that the device is protected by a
residual current device with a rated residual current of maximum 30 mA. Only operate
the device from a properly installed socket. Keep the power plug and all connection points
dry! Lay the connection cable in a protected manner so that damage is impossible. Only
use cables, installations, adapters, extension or connection cables with protective contact
that are approved for outdoor use. Do not carry or pull the device by the connecting
cable! The device must not be operated if the cable or housing is defective! If the power
cord of the device is damaged, the device must be disposed of; it is no longer possible to
replace the power cord. If the cable is damaged, the device must be disposed of. Electri-
cal installations on garden ponds must comply with international and national installation
regulations. Never open the housing of the device or its associated parts unless this is
expressly stated in the instructions for use.
Never make technical changes to the device, this leads to the immediate expiry
of all warranty and guarantee claims. Use only original spare parts and accessories.
Have repairs carried out only by authorized customer service centers.
Never operate the device without water flowing through it! Never convey li-
quids other than water!
If you have any questions or problems, please contact a qualified electrician for your own
safety!
SAFETY INFORMATION LED
Caution, LED light: do not look into the LED light beam! Do not look at it directly or with
optical instruments!
SETTING UP AND COMMISSIONING
Attention! Never operate the device without a pre-filter and without water
flow!
The device is only to be positioned and operated horizontally on the water surface. The
submersible pump included in the scope of delivery must be installed below the surface
of the water (submerged). Establish the hose connection and fix it with a hose clamp. The
device switches on automatically as soon as you have established the power connection.
8