Publicidad
Idiomas disponibles
Idiomas disponibles
12. SIMPLE REPAIR METHODS
Problem
Not enough
heat or Too
heat
No steam or
Leakage
No burst of
steam or no
vertical steam
Leaking water
from Sole-
plate
Little Steam
No Spraying
Possible Reasons
Rotate thermostat dial improperly
or unplugging
The thermostat dial has been set
to MIN
The (vertical) burst of steam func-
tion has been used too often within
a very short period. The iron is not
hot enough
Set the thermostat dial out of
steam range
The heat is still not enough
The water is over than max position
Check if the steam selector is in
proper location
Steam hole is blocked
Poca agua en el depósito
No enough pressure or air inside
Measurement
Correct Thermostat dial in
position and check if the
iron is plugged
Set the thermostat dial to
the required position
Continue ironing in horizon-
tal position and wait a while
before using the (vertical)
burst of steam function
again
Set the thermostat dial as
per steam range
Open steam button only
after the indicator light goes
off
Pour out the remaining
water
Set the steam selector to
the proper location
Clean hole with distilled
water
Llenar de agua el depósito
Press the spray nozzle by
hand, and push the spray
button several times conti-
nuously
Publicidad
