MSW Motor Technics BLS-A001 Manual De Instrucciones página 28

Important: for safety reasons, the unit can only be started if both the
trigger lock release button and the trigger itself are pressed
simultaneously.
Releasing either of these two will immediately stop the machine.
3.3.3 CUTTING
Do not apply the cutting tip to the workpiece before turning the
machine on.
3.3.4 CUTTER REPLACEMENT
To replace the cutter, unscrew the nut on the cutter to remove the
cutter and access the cutter.
Refer to the assembly diagram below for cutter removal and
replacement:
One of the signs that the cutter needs to be replaced is, for example,
chipped edges of cut surfaces.
3.4.
Cleaning and maintenance
a) Cleaning
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
Wait until the rotating parts stop.
•
and maintenance