Descargar Imprimir esta página

MSW Motor Technics MSW-CRF40-50W Manual De Instrucciones página 23

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 71
If for 10 seconds the "SET" button is not pressed, the refrigerator
automatically quits the advanced parameters mode.
"POWER" indicator light
During operation, the "POWER" indicator light glows red, in the ECO mode
the "POWER" indicator lights green. No lighting signalises that the device is
turned off.
"ERROR" indicator light
In the event of a malfunction or failure, the blue "ERROR" indicator will light
up, an audible alarm will sound and an error code will be displayed.
3.4. Cleaning and maintenance
a)
Before cleaning, adjustment or replacement of accessories, and when the
device is not in use, pull the power supply plug and let the device cool down
completely.
Wait until the spinning elements stop.
b)
Use only non-corrosive agents for cleaning the surface.
c)
Only mild cleaning agents designed for cleaning surfaces which come into
contact with food may be used to clean the device.
d)
After each cleaning, all components should be well dried before the device is
used again.
e)
Do not spray the device with a stream of water and do not immerse it in water.
f)
Ensure that no water enters through the ventilation openings in the housing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Use a soft, damp cloth for cleaning.
i)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or metal
scraper) as these may damage the surface of the device.
j)
Do not clean the unit with acidic substances, medical products, thinners, fuel,
oil or other chemicals as they may damage it.
k)
The device features a closed circuit of the refrigerant and it does not require
periodic filling. The filling should be done only in the case of repair works
related to system leakage.
l)
If the device is not used for a prolonged time, disconnect it from the power
supply, wait until it is completely defrosted and remove all moisture from
inside. You can also leave the device with the cover slightly open, which will
ensure the exchange of air inside the device.
DISPOSAL OF USED DEVICES
At the end of its service life, this product must not be disposed of with normal
household waste, but should be taken to a collection point for the recycling of
electrical and electronic devices. This is shown by the symbol placed on the
product, operating manual or the packaging. The materials used in the device can
be reused according to their intended use. By reusing materials or conducting

Publicidad

loading