Publicidad
Idiomas disponibles
Idiomas disponibles
General Installation Information
The PHZC32F, PHZC36F, and PHZC42F models are radiant vent-free fireboxes .
The PHZC32C, PHZC36C, and PHZC42C feature a self contained heat-circulating system .
This installation manual will enable you to obtain a safe, efficient and dependable installation of your vent-free fireplace system .
Do not alter or modify the firebox or its components under any circumstances . Any modification
or alteration of the firebox system, including but not limited to the firebox and accessories, may void the warranty, listings and approvals of
this system and could result in an unsafe and potentially dangerous installation .
BEFORE YOU START
Carefully inspect the contents for shipping damage . If any parts are missing or damaged, immediately inform the dealer from whom you
purchased the appliance . Do not attempt to install any part of the appliance unless you have all the parts in good condition .
MAKE SURE YOU HAVE RECEIVED ALL PARTS
Check your packing list to verify that all listed parts have been received . You should have the following:
1 . Vent-Free Gas Firebox
2 . Canopy/Hood
3 . Installation and Operating Instructions
4 . Three (3) sheet metal screws for
canopy/hood
WHAT YOU WILL NEED FOR INSTALLATION TOOLS and BUILDING SUPPLIES
• Phillips screwdriver
• Square
• Framing materials
• Hammer
• Saw and / or saber saw
• Tee joint
• Level
• Pipe wrench
• Measuring tape
• Pliers
• Electric drill and bits
• Fireplace surround materials (noncombustible)
• Caulking material (noncombustible)
• Wall finishing materials
• Piping complying with local codes
• Pipe sealant approved for use with propane/L .P .G . (resistant to sulfur compounds)
Refer to the installation instructions provided with the log sets for items required for log set installation .
In planning the installation for the appliance it is necessary to determine where the unit is to be installed and whether optional accessories
are desired . Gas supply piping should also be planned . The following steps represent the normal sequence of installation . Each installation
is unique, how-ever, and might require a different sequence .
1 . Position firebox prior to framing or into prepared framing .
2 . Field wire main power supply to models with fan kit . (Electrical connections should only be performed by an experienced, licensed /
certified tradesman) .
3 . Plumb gas line . (Gas connections should only be per-formed by an experienced, licensed/certified tradesman) .
4 . Install vent-free gas log heater per the instructions provided with the vent-free gas log heater .
5 . Complete finish wall material, surround and optionalhearth extension to your individual taste .
5 . Six (6) standoff brackets, (4) side mounted and (2) top mounted
6 . Twelve (12) sheet metal screws for standoff brackets
5
Publicidad
