Daewoo DCS6524 Manual Del Usuario página 17

EN
7. MAINTENANCE
WARNING!
Before attempting to clean, inspect, or repair your chainsaw make sure the engine
is off and cool. Disconnect the spark plug wire to prevent the engine from accidentally
starting.
- MAINTENANCE AFTER EACH USE
1. Air filter
Dust on the surface of the filter can be removed by tapping a corner of the filter
against a rigid surface. To clean the dirt from the screens, divide the filter into two
halves and brush it with gasoline. If you use compressed air, blow from the inside.
OWNER'S MANUAL | ENGLISH
To assemble the two filter halves, press the edge until it clicks.
IMPORTANT:
When installing the main filter, check that the grooves on the edge of the
filter are fully wedged and that it is perfectly adjusted in the carburetor inlet.
2. Oil filler neck
Remove the guide bar and check that the oil filler neck is not clogged or dirty.
3. Guide bar
Remove guide bar and remove all remaining sawdust from guide bar slot and oil
filler neck. Grease the sprocket through the lubrication hole located at the end of the guide bar.
4. Others
Check for fuel leaks or loose connections. Examine the main parts for possible signs
of damage especially the handlebar and its anchoring parts. Also check the mounting of the guide
bar.
If defects are found, make sure necessary repairs are made before using the unit
again.
17