Daewoo DCS6524 Manual Del Usuario página 8

FROM VIBRATIONS
Always use the right tool for the job. Check tools before use to make sure they are in good mainte-
nance or have been properly repaired to avoid further
vibration. Make sure the chain is sharp.
Reduce the time you use the machine without stopping. Avoid putting too much pressure on the
chainsaw when cutting. Store the chainsaw so that its handles are not too cold the next time you
use it.
Stimulate good blood circulation: keeping your body warm and dry.
To gain blood flow it is advised not to smoke and to massage and exercise your fingers regularly.
When you decide to dispose of the machine, fuel and oil, be sure to do so in accordance with the
legislation in force in your area.
2. EXPLANATION OF THE SYMBOLS ON THE MACHINE
For continued use and maintenance, the following symbols have been
embossed or by means of adhesives on the machine.
Regarding these symbols, be careful not to make any mistakes:
Fuel tank location.
Position: near the fuel cap.
Chain deposit location.
Position: near the oil plug.
Indication that by lowering the
switch to position 0, the engine
is stopped.
Position: left rear of the engine.
Gasoline choke, when you pull
it, extra gasoline will enter.
Position: choke lever.
The screw located under the "H" mark is the high speed adjusting screw.
Position: rear left.
The screw located under the "L" mark is the low speed adjusting screw.
Position: rear left.
The screw located under the "T" mark is the idle adjusting screw.
Position: rear left.
8