VALBERG 10S44 D SAD929C Manual De Instrucciones página 13

B
Using the appliance
Strwash
To wash very dirty, hard to clean dishes. (It can only be
used with Intensive, Universal, ECO, Glass, 90 min )
Extra Drying
Function
10 For better drying result. (It can only be used with
indicator
Intensive, Universal, ECO, Glass, 90 min )
Express
Reduce the program time. (It can only be used with
Intensive, Universal, ECO, Glass, 90 min)
Rinse Aid
If the "
low on dishwasher rinse aid and requires a refill.
Salt
Warning
11 If the "
indicator
low on dishwasher salt and needs to be refilled.
Water Faucet
If the "
closed.
12
Screen To show the and delay time, error code etc.
Water softener
• The water softener must be set manually, using the water hardness dial.
• The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
• The more minerals there are, the harder your water is.
• The softener should be adjusted according to the hardness of the water in your area.
• Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
• The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
• Please follow the steps below for adjustment in salt consumption.
1. Close the door, switch on the appliance;
22
" indicator is lit, it means the dishwasher is
" indicator is lit, it means the dishwasher is
" indicator is lit, it means the water faucet
EN
B
Using the appliance
2. Within 60 seconds after the appliance was switched on, press the Programme button for
more than 5 seconds to start the water softener setting mode;
3. Press the Program button again to select the proper setting according to your local
environment, the setting will change in the following sequence:
H1 -> H2 -> H3 -> H4 -> H5 -> H6.
4. Press the Power button to end the setting mode.
WATER HARDNESS
German French British
Mmol/l
dH fH Clarke
0 - 5 0 - 9 0 - 6 0 - 0,94
6 - 11 10 - 20 7 - 14 1,0 - 2,0
12 - 17 21 - 30 15 - 21 2,1 - 3,0
18 - 22 31 - 40 22 - 28 3,1 - 4,0
23 - 34 41 - 60 29 - 42 4,1 - 6,0
35 - 55 61 - 98 43 - 69 6,1 - 9,8
1°dH=1.25 °Clarke=1.78 °fH=0.178mmol/l
The factory setting: H3
Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
1)
energy consumption increases by 0.02 kWh and the program extents by 4 minutes.
NOTE
Please check the "Loading The Salt Into The Softener", if
your dishwasher lacks salt.
23
Regeneration
Salt
Water occurs every
consumption
softner level X program
(gram/cycle)
sequence
1)
No
H1
regeneration
H2 10
H3 5 12
H4 3 20
H5 2 30
H6 1 60
EN
0
9