Gardigo 60062 Manual De Instrucciones página 12

on the function. We recommend installing the device, so that it cannot be reached by
the cat, as it might find an interest in the source of the uncomfortable noise and try
to destroy it.
Installing the device with the bracket
• Release the mounting bracket from the housing by pushing it upwards. The moun-
ting bracket can be found at the back of the housing.
• Screw the mounting bracket with the supplied screws to a wall, a fence, a tree or any
similar place.
• After mounting, the device will easily slip into the bracket.
Use
• The device is switched on with the I/O switch
movement, the red control LED
• Put the device into the bracket or onto a table or shelf. To place it on table, turn the
device 180° around. This will have no influence on the performance, as is the detec-
tion angle is 70° in all directions.
• Make sure that the motion sensor has a clear view of the area it is intended to cover.
• The test button
hear the ultrasonic sound, but the device will emit a functional test sound that is
audible to humans. Do not hold the device directly to your ear.
6. Specifications
• F requency response: 55.000 Hz
• D etection angle: 70°, 7 m range
• E ffective coverage: up to 7 m
• S ound pressure: up to 90 dB
• P ower supply: 6 x AA 1,5 V Mignon batteries
• P ower supply: DC 9 V, 100 mA
• W orking temperature: 0 °C to + 50 °C und ≤ 90 % R.H.
• S torage temperature: 0 °C to + 50 °C und ≤ 90 % R.H.
• P rotection: IP44
12
will light up.
allows you to check, if the device is fully functioning. You cannot
. When the motion sensor recognises