Wheel Locks; Xtr Suspension Anti-Tip Tubes - Sunrise Medical Quickie 5R Manual De Instrucciones

Q UI C KIE 5R
26 27
E. WHEEL LOCKS
Quickie 5R is shipped with one of two types of wheel locks. Wheel locks are installed at the factory
unless you have requested otherwise.
Use a torque setting of 100 in-lbs. (11.3 Nm) when setting up wheel locks.
1. High-Mount Push-to-Lock or Pull-to-Lock Wheel Locks Adjustment
a. Using a 4mm Allen wrench, turn one of the screws (A) in the clamp counterclockwise 1/4
turn.
b. Repeat the same process with the remaining screw (A).
c. Alternately loosen the screws (two turns each) until both screws are loose.
d. Slide clamp toward the rear wheel until the wheel lock is embedded into the tire to prevent
wheel movement when in the locked position.
e. You can achieve extra lateral or angular adjustment by loosening the screw (B) on the wheel
lock receiver clamp.
f. Tighten screws to
100 in-lbs. (11.3 Nm)
2. Ergo Scissor Wheel Locks or Compact Wheel Locks
a. Using a 4mm Allen wrench, turn one of the screws
(A) in the clamp counterclockwise one-quarter turn.
b. Repeat the same process with the remaining three screws (A).
c. Alternately loosen the screws (two turns each) until both screws are loose.
d. Slide clamp toward the rear wheel until the wheel lock is embedded into the tire to prevent
wheel movement when in the locked position.
e. You can achieve extra lateral or angular adjustment by loosening the screw (B) on the wheel
lock receiver clamp.
f. Tighten screws to
100 in-lbs. (11.3 Nm)
NOTE – Clamp and wheel lock may need to be rotated to clear frame tubing.
F. XTR SUSPENSION ANTI-TIP TUBES (Option)
Sunrise Medical recommends anti-tip tubes for all wheelchairs.
NOTE –Use torque setting of 100 in./lbs. when setting-up anti-tip tubes.
1. Adjusting Anti-tip Receiver
a. Remove anti-tip tubes (G) from anti-tip receivers (H).
b. Remove button head bolt ( I ) from anti-tip tube receiver.
c. Reposition bracket to desired height.
d. Reinsert button-head bolt and tighten.
e. Repeat with second anti-tip tube receiver. Both brackets should be at exactly the same height.
26
.
27
.
28
21
26
B
27
B
28
G
H
I
MK-100083 Rev. A